| 本文已被：浏览次 下载次 |
码上扫一扫！ |
|
|
| 随钻电磁波测井仪器结构影响的三维有限元模拟 |
|
许巍1,2,柯式镇1,2,李安宗3,陈鹏3,朱军3,桑泉3
|
|
(1.中国石油大学油气资源与探测国家重点实验室,北京 102249;2.中国石油大学地球物理与信息工程学院,北京 102249;3.中国石油集团测井有限公司随钻测井仪器研究中心,陕西西安 710061)
|
|
| 摘要: |
| 利用三维有限元方法模拟钻铤、线圈衬底、天线槽、天线槽填充物及屏蔽罩等仪器结构对随钻电磁波测井响应的影响。结果表明:实际仪器结构中低阻的钻铤、线圈衬底和屏蔽罩导致电磁信号明显衰减,而高阻的天线槽填充物对仪器信号无明显影响。在兼顾仪器机械强度的条件下,通过减小天线槽深度、增大天线槽长度和占空比可以降低电磁信号衰减。仪器结构影响导致仪器响应随地层电阻率非线性变化,扣除仪器结构影响后,仪器响应恢复了随地层电阻率在较宽范围内线性变化的关系,可以满足仪器线性刻度需要。由于扣除仪器结构影响后线圈中磁通量减小,仪器响应略小于无仪器结构影响时的响应。 |
| 关键词: 随钻测井 有限元方法 仪器结构 电磁波传播 |
| DOI：10.3969/j.issn.1673-5005.2016.06.006 |
| 分类号::P 631 |
| 文献标识码:A |
| 基金项目:国家油气重大专项(2011ZX05020-002) |
|
| Structural effects analysis of an electromagnetic wave propagation resistivity LWD tool by 3D finite element method |
|
XU Wei1,2, KE Shizhen1,2, LI Anzong3, CHEN Peng3, ZHU Jun3, SANG Quan3
|
|
(1.State Key Laboratory of Petroleum Resources and Prospecting in China University of Petroleum, Beijing 102249, China;2.College of Geophysics and Information Engineering in China University of Petroleum, Beijing 102249, China;3.China Petroleum Logging Company Limited, Xi 'an 710061, China)
|
| Abstract: |
| The effects of metal mandrel, coil substrate, antenna slot, antenna slot filling material, and shield cover of an electromagnetic wave propagation resistivity logging while drilling(LWD) tool were simulated by a 3D finite element method. The results show that the low resistivity of metal mandrel, coil substrate, and shield cover can lead to significant electromagnetic signal reduction, whereas the effect of the slot filling material with high resistivity is nearly negligible. Under the consideration of mechanical strength, the attenuation of electromagnetic signal can be minimized via increasing the slot length, enlarging the space proportion of slot, and reducing the slot depth. The structural effects may result in nonlinear response changes with the formation resistivity; after eliminating the structural effects, the responses recover to change linearly with the formation resistivity in a broad range, satifying the requirement of linear calibration. However, due to the decrease of magnetic flux in the coils after eliminating the structural effects, the tool responses may become smaller than those without the structural effects. |
| Key words: logging while drilling finite element method instrument structure electromagnetic wave propagation |
