引用本文:
【打印本页】   【HTML】   【下载PDF全文】   查看/发表评论  【EndNote】   【RefMan】   【BibTex】
←前一篇|后一篇→ 过刊浏览    高级检索
本文已被:浏览次   下载 本文二维码信息
码上扫一扫!
分享到: 微信 更多
多段压裂水平井不均匀产油试井模型
何佑伟1,2,程时清1,2,胡利民1,2,方冉1,2,李双3,汪洋1,2,黄瑶1,2,于海洋1,2
(1.中国石油大学油气资源与工程国家重点实验室,北京 102249;2.中国石油大学石油工程教育部重点实验室,北京 102249;3.中海油能源发展股份有限公司工程技术深圳分公司,广东深圳 518607)
摘要:
针对某条或多条裂缝产油量较小或不产油这一问题,运用Green函数、Newman乘积方法和叠加原理,建立多段压裂水平井不均匀产油试井模型,将裂缝内流动划分为远离井筒的变质量线性流和靠近井筒的径向流表征裂缝有限导流,利用Stehfest数值反演得到考虑井筒存储和表皮效应的实空间井底压力解,绘制典型图版,并分析不均匀产油和裂缝参数对井底压力的影响。结果表明:多段压裂水平井均匀产油和不均匀产油的压力和压力导数特征差异明显;两端裂缝产油量越大,压裂裂缝间距越大,裂缝半长越小,裂缝呈纺锤形分布时,缝间干扰越小,早期径向流越明显,在系统拟径向流之前出现一个新平台。与试井软件Saphir中的经典多级压裂水平井数值模型对比,结果证明了提出的模型的正确性。
关键词:  水平井  不均匀产油  试井分析  格林函数  Newman乘积方法  典型曲线
DOI:10.3969/j.issn.1673-5005.2017.04.015
分类号::TE 353
文献标识码:A
基金项目:国家科技重大专项(2016ZX05009-004,2016ZX05013001-005)
A pressure transient analysis model of multi-fractured horizontal well in consideration of unequal production of each fracture
HE Youwei1,2, CHENG Shiqing1,2, HU Limin1,2, FANG Ran1,2, LI Shuang3, WANG Yang1,2, HUANG Yao1,2, YU Haiyang1,2
(1.State Key Laboratory of Petroleum Resources and Engineering in China University of Petroleum, Beijing 102249, China;2.MOE Key Laboratory of Petroleum Engineering in China University of Petroleum, Beijing 102249, China;3.Engineering Technology Shenzhen Branch, CNOOC Energy Technology & Services Limited, Shenzhen 518607, China)
Abstract:
In this study, the effect of unequal production of each fracture (UPEF) on well testing behavior was considered in order to develop a pressure transient analysis (PTA) model for multi-fractured horizontal wells (MFHW), and semi-analytical solutions were given based on the Green 's function, the Newman 's product method and superposition principles. The flow in a hydraulic fracture is divided into two flow regimes (i.e. a variable-mass linear flow far from the horizontal wellbore and a radial flow near the horizontal wellbore) to characterize the finite conductivity flow within the fractures. Then, characteristic pressure curves were obtained using a numerical Stehfest inversion algorithm, and sensitivity analysis (e.g. UPEF, fracture and parameters) was further conducted. The analysis results indicate that there are obvious differences among the type curves obtained via assuming an equal production of each fracture (EPEF) and the UPEF. The early-radial flow behaves as a horizontal line in the pressure derivative curves when the fractures located at the ends of wellbore contribute much more to total oil production than those at the middle section, or when the fractures are wide-spaced and short, or when the fractures behave as spindle shape. In comparison with the classic PTA model of the MFHW in Saphir software, the accuracy and reliability of the newly proposed model has been proven.
Key words:  horizontal well  unequal production of fractures  pressure transient analysis  Green 's function  Newman 's product method  type curves
版权所有 中国石油大学学报(自然科学版)编辑部 Copyright©2008 All Rights Reserved
主管单位:中华人民共和国教育部 主办单位:中国石油大学(华东)
地址: 青岛市黄岛区长江西路66号中国石油大学期刊社 邮编:266580 电话:0532-86983553 E-mail: journal@upc.edu.cn
本系统由:北京勤云科技发展有限公司设计